Galvanised Double Wire Panels for Export Orders
Built to a Specification, Not a Photo
Double wire panels look alike across suppliers until you weigh one. The difference sits in wire diameter, in whether the panel was galvanised before or after welding, and in how the bundle is packed for the container.
For an export order we quote against a written specification and confirm panel weight before production, so the delivered panels match what was priced.
Galvanised Before Welding or After
A hot dip galvanised panel carries zinc over the weld and into the crevice between the paired wires. A pre-galvanised wire that is welded afterwards loses its coating at every crossing, and that bare point is where rust starts on a coastal site.
We state which route the order will use on the quotation, because the two are not interchangeable in service even though they look the same on delivery.
Packing and Bundle Counts
Panels are stacked face to face with interleaving and steel banded into bundles, typically 20 to 50 panels depending on height. Bundle weight is kept inside what a forklift can handle at the destination port.
Bundles are labelled with panel size and quantity so the site can allocate without unpacking everything.
Container Loading
Double wire panels nest, so a 40 ft container carries a large quantity of 2.4 m panels when they are loaded as bundles rather than loose. Posts and fittings travel in the same container unless the order is large enough to separate them.
We confirm the loading plan and the number of bundles per container before the order is released, and send loading photographs with the shipping documents.
Order Sequence
A typical order runs: specification confirmed, deposit received, wire drawn and welded, galvanising, packing, loading. Galvanising is the step that sets the lead time, because it is outsourced to a bath rather than run in line.
If a delivery date is fixed, tell us at enquiry stage and we will quote the sequence that meets it rather than the cheapest one.