Construction Safety Barrier Temporary Fence
A Safety Barrier, Not Just a Boundary
On a site next to a footpath the fence has two jobs: keep people out of the works, and let them see the works so they do not walk into it. Those aims pull in opposite directions on mesh choice.
An open mesh that keeps sightlines is usually the right answer; a solid hoarding is used where the works are dangerous to look at, not merely to enter.
Set-Out and Pedestrian Route
The run should follow the hoarding line and leave a walkway at least as wide as the original footpath. Where the path has to be diverted, the diversion is part of the barrier design, not an afterthought.
Corners and gate openings are where pedestrians get surprised, so they get the clearest sightlines.
Ballast on Public Ground
Feet must not become trip hazards. On a footpath the foot is set outside the walkway, or a flat concrete block is used instead of a blow moulded foot standing proud of the surface.
On a slope the run steps rather than following the gradient, so panels stay vertical and feet stay flat.
Visibility and Marking
Orange or yellow coated panels read from a distance and in poor light. Where the fence is on a road, reflective bands or a marker board at the ends are added on top of the colour.
Couplers and feet should be in the same colour so the run does not read as a series of unrelated objects.
Gates and Access Control
A pedestrian gate keeps the access point in one place instead of leaving a gap that grows. Vehicle gates need their own posts and feet, because the leaf weighs more than a panel.
A gate that will not close is worse than no gate: it teaches people to leave the opening.