Chain Link Portable Panels for Temporary Fences
Chain Link in a Portable Frame
Chain link is a woven mesh, so it has no stiffness of its own. In a portable panel it is stretched between two uprights inside a tube frame, and the frame supplies the rigidity the mesh lacks.
That is why a slack panel drums in wind while the frame stays still: the mesh is doing no work.
Tension and the Frame
The mesh is held by a tension bar at each end and pulled against the frame. Knuckled edges are safer to handle; barbed edges grip the tension bar better and are used where the panel is expected to stay tensioned.
Panels that arrive slack have usually been cut short rather than badly woven.
Mesh and Wire
Common mesh is 50 mm or 65 mm on 2.5 mm to 3.5 mm wire. Heavier wire resists cutting and denting; lighter wire is easier to handle and cheaper.
Because the mesh is woven, a cut does not run: chain link is harder to open up than a welded grid, which is why it is still chosen on sites where cutting is a risk.
Feet, Couplers and Corners
Panels stand in plastic or concrete feet and couple at the uprights. The coupler should allow an angle at corners, and the corner panel carries more load than any other.
On a long straight run, every third or fourth panel benefits from a heavier foot.
Where It Is Used
Construction perimeters, utility compounds, event boundaries and sites where the fence has to resist cutting rather than impact.
Where the site changes shape often, a welded panel handles better; where the fence stays put and security matters, chain link is the better choice.