Reinforcing Welded Mesh Used as Fence Panels
Why Reinforcing Mesh
Reinforcing mesh is made for concrete, not for fences, and that is exactly why it is cheap: the wire is heavy, the grid is regular, and it is produced in enormous volume. Used as a fence panel it gives a stiff, hard-wearing barrier at a low price per square metre.
The trade-off is appearance and finish. It is a functional panel, not a decorative one.
Grid and Wire
A 6x6 reinforcing panel carries 4 mm to 6 mm wire on a 150 mm grid. That is heavier than most fence panels and stiffer across the span, which is why it can be used without a folded edge.
The wire is stiff enough that the panel does not need a frame to hold its shape between posts.
Where It Underperforms
Cutting: a heavy wire grid is difficult to cut, which is an advantage, and also means site alterations are slow. Appearance: the mesh is often supplied mill or lightly coated, and it looks industrial.
Climb resistance: a 150 mm grid is a foothold. Against a determined climb it performs worse than a small-aperture panel, despite the heavier wire.
Posts and Spans
Because the panel is stiff, spans can be wide, but the post has to carry the weight - a 6 mm grid is heavy. Post spacing is often set by panel weight rather than by wind.
Fixing through a heavy wire grid needs a clamp that seats on the wire, not a bolt that flattens it.
Coating
Galvanised after welding is the only sensible route for a welded heavy panel: the weld is where corrosion starts, and on a 150 mm grid there are relatively few crossings to protect.
Powder coating over the zinc is used where the panel is visible; without it, the fence reads as construction material.