4 m High Chain Link Sports Fence
Height Comes From the Ball
A sports fence is taller than a boundary fence because it has to stop a ball, not a person. The height is set by the trajectory of the ball from the furthest point of play, not by a standard dimension.
4 m is typical for a full-size pitch or a multi-use games area; a small training area can work at 3 m, a full-size ball court usually needs more.
Post and Bracing
At 4 m the wind load and the impact load both rise sharply. Posts are heavier sections, set deeper, and often braced at the top or tied back with a stay wire at each end of the run.
A 4 m post on a footing sized for a 2 m fence will lean; the footing, not the post, is the part that gets under-designed.
Mesh and Wire
Sport mesh is usually 45 mm to 50 mm on 3 mm to 4 mm wire. A tighter mesh stops smaller balls; a heavier wire resists the repeated impact that loosens a light mesh at the knuckles.
On a ball-stop fence the bottom 2 m takes most of the hits, so some schemes specify a heavier gauge low down and a lighter mesh above.
Tension and Fittings
Chain link is only rigid when tensioned. A 4 m run needs a top rail or a tension wire at the top, tension bars at every end and corner, and strainers to pull the mesh.
Without a top rail the mesh drums in wind and the fence reads as slack even when it is brand new.
Gates and Access
Access gates are built from the same frame with a heavier section, hung on posts set deeper than the line posts. Wide double leaves sag unless they carry a wheel or a drop bolt.
Where maintenance vehicles need access, the gate width is usually set by the mower, not by the players.