3D fence

Triangle Bend 3D Fence Panels

Triangle bend 3D fence panels: what the deeper V fold does to stiffness, how bend depth and wire size interact, and where the panel is specified.
  • Triangle Bend 3D Fence Panels
  • Triangle Bend 3D Fence Panels
  • Triangle Bend 3D Fence Panels
  • Triangle Bend 3D Fence Panels
Triangle Bend 3D Fence Panels
Green post and 3D panel with clamp detail

The Bend as Structure

A 3D panel gets its rigidity from pressed folds in the horizontal wires. The triangle or V pattern is the deeper version: fewer folds, each running deeper into the panel, so the section acts more like a beam and less like a corrugated sheet.

Deeper folds carry more load over the same span, which is why a triangle-bend panel can be used where a shallow-bend panel would wave between posts.

Bend Depth and Wire

Three numbers that must agree

Wire diameter, bend radius and fold depth are set together. A heavy wire folded at a tight radius cracks at the outside of the bend; a light wire folded deep springs back and loses its shape.

Tooling decides what is possible, so the panel should be specified by wire, aperture and fold depth rather than by a photograph of a similar fence.

Close view of the pressed bend in a 3D panel

Aperture and Height

3D panel run installed between square posts

The common grid is 50 x 200 mm on 4 mm to 5 mm wire. A tighter aperture adds climb resistance and weight; it does not add stiffness, which comes from the fold.

Panels are usually 2.5 m wide and up to about 2.4 m high. Taller panels need a heavier post rather than a deeper fold.

Where It Is Specified

Industrial boundaries, utility compounds, sports facilities and long straight runs where the fence has to stay flat without an extra frame.

The triangle bend also reads as a heavier fence than a flat mesh, which matters on a site where the boundary is part of the presentation.

3D panels installed along a building boundary
3D curved panel shown on its own

Coating and Fixing

Galvanised then powder coated is the durable build; the fold is pressed before coating, so the finish runs through the bend.

Panels fix to posts with through bolts or clips. On a deep-fold panel the fixing must sit on a flat part of the wire, or the clamp works loose as the panel moves.

What to Send

3D panels loaded in a container

Send panel height and width, wire diameter, aperture, fold depth, coating and colour, post section, quantity and the port of discharge.