3D Curved Wire Mesh Fence Panels
What the Bend Does
A 3D panel is a welded grid with the horizontal wires pressed into a shallow V across the panel. That fold turns a flat sheet into a shallow beam, so the panel resists bending across its whole height instead of along individual wires.
The result is a panel that spans wider between posts and stays flat after handling, without a separate frame section.
Wire and Aperture
Common builds are 3 mm to 5 mm wire on a 50 x 200 mm or 55 x 200 mm grid. Heavier wire resists cutting; tighter aperture resists climbing but adds weight and wind load.
The bend is pressed after welding, so the wire size has to suit the tooling - a heavier wire needs a bigger radius or it cracks at the fold.
Panel Sizes
Panels are usually 2.5 m wide and 1.0 m to 2.4 m high. Height above 2.4 m is normally a different system rather than a taller panel, because the bend loses effectiveness as the panel gets taller.
Panel width is set by what two people can carry and by the post spacing the site can accept.
Coating
Galvanised wire welded then powder coated is the durable build. Coating over untreated wire looks the same on delivery and fails at the first scratch, because there is no zinc under the film.
Green and black are the common colours; the finish should be a RAL reference where it has to match an existing fence.
Packing
Panels nest when stacked and take far less volume than their face area suggests, which is why a container carries a large quantity of 3D panels compared with rigid framed panels.
Bundles are banded and labelled by size; mixed sizes in one bundle slow the site down.