3D Curved Mesh Fence System with Posts
Panel Plus Post
A 3D fence is a system: the panel provides stiffness, the post provides the line, and the fixing joins them. Change any one and the run behaves differently.
Because the panel is stiff, post spacing can be wider than a flat mesh fence - but the post section still has to carry the wind load on the panel area.
Posts and Fixings
Square or rectangular hollow section posts are usual, with panels bolted through the post face or held by steel clips. Bolted fixings are more rigid; clips are quicker and allow a little movement.
Post caps keep water out. An open post top collects rain and rusts from the inside, which is invisible until the base fails.
Setting Out a Run
Set the corner and end posts first, then line posts at the panel centres, then fix panels. Working from one end leaves the closing gap at the far corner.
On sloping ground the panels step rather than follow the gradient, so each panel stays vertical and the top line steps.
Heights and Gates
Runs are commonly 1.2 m to 2.0 m high. Above that the panel needs a heavier post section rather than a taller panel on the same post.
Gate leaves are built from the same panel with a frame; the gate posts are set deeper and are not spaced to the panel centres.
What Keeps a Long Run Straight
Post spacing, foundation depth and the fixing detail. A run that waves after a season usually has posts set too shallow or fixings that allow movement at every panel.
On exposed ground, shortening the span is cheaper than thickening the post.