358 Security Fence

Green Powder Coated 358 Anti-Climb Fence for Secure Sites

Colour is the last decision on a 358 panel and the first thing anyone notices. This page covers what the powder coat actually protects, how it is applied over galvanising, and where a green run is the right specification.
  • Green Powder Coated 358 Anti-Climb Fence for Secure Sites
  • Green Powder Coated 358 Anti-Climb Fence for Secure Sites
  • Green Powder Coated 358 Anti-Climb Fence for Secure Sites
  • Green Powder Coated 358 Anti-Climb Fence for Secure Sites
Green Powder Coated 358 Anti-Climb Fence for Secure Sites
Green powder coated 358 anti-climb mesh panel with folded edges on a white background

What the Colour Is For

A green 358 run does two jobs at once. It marks the boundary without turning the site into a compound, and it gives the panel a second barrier on top of the galvanising.

Colour is the part clients ask about first and the part that changes the fence least. What decides how the run lasts is the zinc underneath the green, not the shade on top of it.

What the Powder Coat Sits On

The coat is applied over hot dip galvanised wire, never directly over bare steel. The zinc is the corrosion barrier; the powder is a colour and a second barrier over it.

Why the order matters

A powder coat film is continuous until it is damaged. Where it is scratched through, the steel is exposed unless there is zinc under the film to sacrifice itself first. On a coated panel, the galvanising is what keeps a scratch from becoming a rust line.

This is why a cheaper panel coated over untreated wire looks identical on delivery and fails differently in service. The difference appears at the cut ends and at the welded joints, which are the two places a film is thinnest.

Clips, caps and gate hardware are quoted against the post section and the leaf weight, so nothing on site has to be improvised.

Close-up of the clamp fixing and post connection on a green 358 panel

How the Coating Is Applied

Folded edge and clamp detail on a 358 mesh panel

The panel is welded, galvanised, then coated, and the cut ends are treated after fabrication.

Where a coated fence fails first

Transport damage and site handling are the usual causes, not the coating process. A panel dragged across a kerb loses its film along the bottom edge, and that edge sits in the wettest part of the fence.

Touch-up on site is part of the job. A coated run that is delivered perfect and installed without touching up will still show rust at the contact points within a few seasons.

Where a Green Run Belongs

Green is specified where the fence has to be seen as a boundary rather than a barrier.

  • Corporate and commercial perimeters

  • Sites adjoining planting, grass or a public footpath

  • Runs where a galvanised finish would read as industrial

  • Boundaries under floodlight, where a light finish glares

Green 358 fence run seen against a landscaped boundary
358 mesh panels along a building elevation

Colour, Glare and Visibility

A dark green panel absorbs light instead of reflecting it. Under floodlights that means the fence does not throw glare back at the site, and at night it reads as a line rather than a lit surface.

What colour does not change

The aperture, the wire and the post section are identical whatever the colour. Containment comes from the geometry of the mesh, not from the finish, so a green panel and a galvanised panel stop the same climb.

Order Details

Galvanised 358 panels in rows showing the panel edge

Send the run length and height, the colour reference, whether the posts and clips are to be coated to match, the post fixing, and the destination port.

Supply only outside China. Erection is by the client's contractor against our setting-out drawings.